Jack-lanannes-power-juicer power juicer User Manual download pdf (Page 8)

POWER JUICER ELITE

Assembly/Main Unit

STEP 4:

Place blade inside filter, centered

over screw peg. Using orange

crescent tool, place its pegs

into the holes on the blade.

Turn clockwise while holding

the filter and receptacle in place

until tight (as shown).

STEP 6:

Place lid with built-in pulp guard on top

of receptacle, making certain it is snugly

aligned with the pulp guard facing in

the opposite direction of the juice spout.

STEP 5:

Place the pulp collector so that it rests

under the backside of the juicer.

POWER JUICER ELITE

IMPORTANT: There are MIN/MAX arrow markings on the

orange rim of the filter. These markings prevent you from

overtightening or undertightening the blade. Crescent

tool should line up between MIN/MAX arrows (as shown).

Remove crescent tool and set

aside. Do not leave tool inside juicer.

Note: Refer to page

6 for all part names.

Main Unit

Micro

Safetyswitch

Assembly

IMPORTANT: There is a Micro Safetyswitch located

in the back center of the pulp collector base.

This mechanism is an added safety feature.

Once the pulp collector is in place it

activates the Micro Safetyswitch.

This will protect you from

accidentally putting hands or

fingers under the machine while

the blade is spinning. Once the

pulp collector is removed from

the main base the motor will

not run.

Micro

Safetyswitch

MIN/MAX

Arrow Markings

Filter

Crescent Tool

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Jack-lanannes-power-juicer power juicer User Manual Page 8

Comments to this Manuals

Related products and manuals for Juicers Jack-lanannes-power-juicer power juicer